A bumper kit of Pyramage and Invertage part 2

Hello crafty friends,

For this card, I've used the same kit and card design as the card that I posted yesterday.

 I started by removing the flower picture (to be used) and leaving the narrow border in place,  then placed it on one side as it's not being used for this card today. 

Using an A5 card, I drew around the outside of the flower picture, opening the card out on the cutting mat, using a metal  edge ruler and a craft knife, I cut the aperture.  I covered the inside back with two different pieces of the insert papers and then covered the front using the same papers and lined them up with the inside of the back through the aperture window, again turning over on the cutting mat and cutting the aperture back in.  I covered the inside front of the card (if that makes sense) with black thin card, I also matted the flower picture onto the same black card.  Using the invertage pieces, I decided on how many to use on the matted design (in this case one), foam pads to attach and lined it up with the design. The next one was glued inside the aperture on the front to the black card that was applied to the back of it and then the smaller aperture cut back in so that the front now has a smaller aperture (sorry, a bit long winded there).  It now looks that only a small aperture was cut.  I cut three Moroccan accent borders in black and two in pink. The black borders were placed around the outside edge of the flower picture creating a frame and the pink ones created a frame around the small aperture on the inside front, I also used the left over black border to hide where the two papers meet in the inside back of the card and placed the flower picture by lining the image up from the front.
The card was finished by placing the rest of the invertage on the front of the card.
Hope you like it and thanks for stopping by
Caz xxx